Variant 1: installed flush in a dropped/coffered ceiling

The TeamConnect Ceiling Medium can easily be installed flush in dropped or closed ceilings.

The TCC M-F product variant includes a ceiling flush mount kit for this purpose. When flush mounting, do not install the TeamConnect Ceiling Medium directly next to lights or other electrical devices in the ceiling.

NOTICE

Danger of property damage if the product should fall

If mounted incorrectly, the product may fall.

When installing in the ceiling, always use additional means to secure the TeamConnect Ceiling Medium against falling, e.g. with the TCC M SK ceiling suspension kit included in the scope of delivery (see variant 3: suspended from the ceiling) and additionally with the supplied safety wire, which is attached to a ceiling hook and the top of the microphone.

Attaching the ceiling flush mount kit

Remove a tile from the ceiling.
Trace the circumference using the drilling template supplied and saw the hole.
Using a suitable anchor, insert an eye bolt into the ceiling to attach the safety wire.
Reinsert the ceiling tile.
Assemble the longitudinal sections of the ceiling flush mount kit by hooking them into each other at right angles and then straightening them out until they snap into place.
Place the longitudinal sections over the crossbeams in the coffered ceiling.
With the C-ring closed or slightly open, guide it through the hole and unfold it.
Slide the tabs on the C-ring onto the longitudinal sections on both sides.
Attach the ceiling flush mount kit by inserting the supplied screws through the slots on both sides.

Securing and connecting the microphone

Mount the safety wire as shown and attach it to the retaining hook and microphone.
If using, mount the TCC M SK ceiling suspension kit (see “Variant 3: Suspended from the ceiling”).
Insert the cables you need.
If required, you can attach a cover plate (included with delivery) and pipe clamps (not included with delivery).
Recommended cabling
Observe the following when connecting and running the cables:
- Always run the cables carefully and in a loop shape inside the installation recess.
- Make sure not to kink the cables to avoid breaking them or damaging the plugs.
Lift the microphone toward the ceiling, pull the safety wires tight and cut off any protruding length of wire.

Securing the microphone and attaching the front panel

Hold the microphone in the ceiling flush mount frame with one hand and use the other hand to screw the three clamps until tight.
Look through the inspection holes to check that the clamps are properly tightened and the microphone is firmly seated in the frame.
Insert the safety wire on the front panel into the corresponding recess in the microphone as shown and secure it with the supplied screw.
Insert the two pins on the retaining plate into the corresponding holes in the microphone (marked in red). Magnets will hold the front panel to the microphone.