Variant 2: mounted directly below the ceiling

For installation directly below the ceiling, you need the TCC M-S-W or TCC M-S-B product variant, or the TCC M-H-W or TCC M-H-B ceiling microphone housing.

Screws and anchors for mounting the product to the ceiling are not included with delivery. Use screws and anchors that are appropriate for the particular characteristics of your ceiling.
Mounting the ceiling mounting frame
  1. Use the drilling template or the housing to draw the keyholes on the ceiling.
  2. Place the screws in the center of the key holes.
Securing and connecting the microphone
  1. Mount the safety wire as shown and attach it to the housing and microphone.
  2. Insert the cables you need.
  3. Lift the microphone toward the ceiling, pull the safety wires tight and cut off any protruding length of wire.

    Observe the following when connecting and running the cables: Always run the cables carefully and in a loop shape inside the installation recess. Make sure not to kink the cables to avoid breaking them or damaging the plugs.
Securing the microphone and attaching the front panel
  1. Hold the microphone in the housing with one hand and use the other hand to screw the three clamps until tight. Caution: left-hand thread!
  2. Look through the inspection holes to check that the clamps are properly tightened and the microphone is firmly seated in the housing.
  3. Insert the safety wire on the front panel into the corresponding recess in the microphone as shown and secure it with the supplied screw.
  4. Insert the two pins on the retaining plate into the corresponding holes in the microphone (marked in red). Magnets will hold the front panel to the microphone.