Variant 3: suspended from the ceiling

For suspended mounting, you need the TCC M-SK ceiling suspension kit.

Screws and anchors for mounting the product to the ceiling are not included with delivery. Use screws and anchors that are appropriate for the particular characteristics of your ceiling.
Drawing the drill holes
  1. Use the drilling template or the housing to draw the keyholes on the ceiling.
Premounting the microphone
  1. Insert the microphone into the housing or slide the housing onto the microphone.
  2. Make sure that the recess in the microphone is aligned with the corresponding hole in the housing.
  3. Secure the microphone using the three clamps. Caution: left-hand thread!
Preparing the ceiling fastener
  1. Unscrew part A of the ceiling fastener from part B.
  2. Thread the steel cable C into part B so that the ball on the steel cable is in part B.
  3. Repeat these steps for the other three fasteners.
Mounting the ceiling fastener
  1. Attach part A of the ceiling fastener to the ceiling using a suitable anchor and screw.
  2. Use the included drilling template to align the drill holes.
  3. Then screw part B of the ceiling fastener into part A.
  4. Repeat these steps for the other three fasteners.
Mounting the product fastener
  1. As shown in the figure, screw the product fastener into the threaded mounting hole on the top of the TeamConnect Ceiling Medium.
  2. Set the steel cable C to the desired length by using your finger to press the cable guide into the product fastener and sliding the steel cable as needed.
  3. Cut the excess steel cable using suitable pliers.
  4. Repeat these steps for the other three fasteners.
  5. Insert the cables you need.
  6. If necessary, use a cable conduit (not included with delivery) to bundle the cables.

Attaching the front panel
  1. Insert the safety wire on the front panel into the corresponding recess in the microphone as shown and secure it with the supplied screw.
  2. Insert the two pins on the retaining plate into the corresponding holes in the microphone (marked in red). Magnets will hold the front panel to the microphone.